Cisco SCE8000 Installation And Configuration Manual page 86

Cabling the 10GBE Line Interface Ports
Take the appropriate fiber optic cable (see
Step 1
appropriate port (A or B) on the external bypass module.
Using a cable with LC connectors on both ends, plug one end into the appropriate port (C or D) on the
Step 2
external bypass module and the other end into the appropriate 10GBE interface in slot #3 of the SCE8000
chassis.
Step 3 Using the control cable provided, which has RJ11 connectors on both ends, plug one end into the CNTRL
interface on the external bypass module (see
interface on the SCE8000-SCM-E in slot #1 of the SCE8000 chassis (see item #1 in
If using only one external bypass module, use External Bypass port #1. If using two external bypass
modules, use both External Bypass ports on the SCE8000-SCM-E in slot #1.
Complete the installation and powering up of the SCE8000.
Step 4
By its nature, the optic bypass module will not connect the link to the SCE8000-SIP module until the
entire SCE8000 system is fully functional. It is necessary to bring the SCE8000 to fully operational,
non-bypassed status, in order to confirm correct functioning of the link through the optic bypass module
to the SCE8000-SIP module.
Step 5 Verify link connectivity by checking that the link LED on the 10GBE interface is green, or by using the
SCE8000 command line.
Figure 6-3
Figure 6-4
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
6-12
Cabling the CNTLR Interface on the External Bypass Module
T X
T X
T X
R X
T X
R X
R X
A R X
B
C
D
Cabling the SCE8000-SCM-E Module
1
S C E 8 0 0 0
-S C M -E
O P T IC A
L
B Y P A S
S 1
Chapter 6 Cabling the Line Ports and Completing the Installation
Fiber Specifications, page
Figure 6-3) and plug the other end into the External Bypass
A
C
B
D
C T R L
A
B
C
D
S T A T U S
O P B — S C
E 8 K — M M
2
3
C O N S O
L E
P O R T 1
1 0 /1 0 0 /
L IN K /
1 0 0 0
A C T IV E
6-10) and plug it into the
Figure 6-4 below).
OL-16478-03