Installing A Module - Cisco SCE8000 Installation And Configuration Manual

Removing and Replacing Modules
Figure 9-9

Installing a Module

Choose a slot for the module.
Step 1
Modules must be installed in the proper slots, as follows:
•
•
•
At the SCE# prompt, type reload shutdown and press Enter to power down the Cisco SCE8000
Step 2
platform before installing or removing any module.
Make sure that there is enough clearance to accommodate any interface equipment that you will connect
Step 3
directly to the module ports.
Step 4 Verify that the captive installation screws are tightened on all modules already installed in the chassis to
ensure that the EMI gaskets on all modules are fully compressed in order to maximize the opening space
for the new or replacement module.
If the captive installation screws are loose, the EMI gaskets on the installed modules will push adjacent
Note
modules toward the open slot, reducing the opening size and making it difficult to install the replacement
module.
Remove the module filler plate by removing the two Phillips pan-head screws from the filler plate. To
Step 5
remove a module, follow the procedure in
Fully open both ejector levers on the new module. (See
Step 6
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
9-14
Handling a SIP
Printed circuit board
Metal carrier
GND
A single SCE8000-SCM-E module must be installed in slot #1.
If a second SCE8000-SCM-E module is used, it must be installed in slot #2.
The SCE8000-SIP module must be installed in slot #3.
Chapter 9
Removing a Module, page 9-18
Figure 9-10.)
Removal and Replacement Procedures
OL-16478-03