Unsupported Configuration - Cisco SCE8000 Installation And Configuration Manual

Figure A-2
Subscriber
In the above configuration, it is essential that the SCE8000 be operating in receive-only mode. Other
Note
configurations may cause SPAN port traffic to be returned to the switch, causing unpredictable behavior.

Unsupported Configuration

Due to the 10GBE characterstics described above, the following configuration is not supported in the 10
GBE environment. In this configuration, the switch port remains in the DOWN state and therefore does
not transmit.
Figure A-3
Subscriber
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
A-2
Supported SPAN Port Configuration
Switch
RX TX
3/0/0 3/1/0
3/2/0 3/3/0
Unsupported SPAN Port Configuration
Switch
RX TX
3/0/0 3/1/0
3/2/0 3/3/0
Appendix A Using Optical Splitters with 10GBE Links
Network
Network
OL-16478-03