Removing A Spa From A Sip; Removing And Replacing The Optical Bypass Module; Removing The Optical Bypass Module; Installing The Optical Bypass Module - Cisco SCE8000 Installation And Configuration Manual

Removing and Replacing the Optical Bypass Module

Removing a SPA from a SIP

To remove a SPA from a SIP, refer
At the SCE# prompt, type reload shutdown and press Enter to power down the Cisco SCE8000
Step 1
platform before installing or removing any module.
If attached, remove any cables from the SPA.
Step 2
To remove the SPA from the SIP, unfasten the captive installation screws on the SPA.
Step 3
Grasp the handles of the SPA and pull the SPA from the SIP.
Step 4
Removing and Replacing the Optical Bypass Module
•
•
•

Removing the Optical Bypass Module

Disconnect all cables.
Step 1
Loosen the two captive screws on the module.
Step 2
Pull the module out of the slot. Place your other hand under the module to support the weight of the
Step 3
module. Do not touch the module circuitry.
Place the module on antistatic foam, or immediately reinstall it in another slot.
Step 4
If the slot is to remain empty, install a module filler plate to keep dust out of the chassis and to maintain
Step 5
proper airflow through the chassis.

Installing the Optical Bypass Module

Remove the module filler plate by loosening the two screws.
Step 1
Insert the module into the opening in the panel. There are no guide rails. Do not touch the module
Step 2
circuitry.
Tighten the two captive screws on the module.
Step 3
Connect the cables as described in
Step 4
Bypass Module, page
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
9-26
Removing the Optical Bypass Module, page 9-26
Installing the Optical Bypass Module, page 9-26
Replacing the Optical Bypass Module without Disrupting Traffic on the Link, page 9-27
6-11.
toFigure 9-17 and do the following:
Cabling the 10GBE Line Interface Ports: Using the External Optical
Chapter 9 Removal and Replacement Procedures
OL-16478-03