Huawei UPS5000-E User Manual page 160

UPS5000-E-(50 kVA-300 kVA)
User Manual (50 kVA Power Modules)
Item
Current
equal.
detection
Bus Capa.
Life
Figure 4-39 Advanced Param. screen 5
Item
Altitude (m)
ModbusTCP
Encryption
Batt.
charging
capacity
mismatch
Battery
segment
detection
Emergency
Shut Down
Enable
Issue 02 (2017-02-25)
Description
zero load.
Monitors the current differences between racks or modules. If this
parameter is set to Enable, the Mod. Cur. Eql. Data can be viewed on
the running information screen. This parameter is set to Disable by
default.
If Bus Capa. Life is set to Enable, the UPS detects the bus capacitor
lifespan.
Description
Set this parameter based on the altitude of the place where the rack is used.
The default value is less than or equal to 1000.
If Modbus TCP is used for communication, communication links
implement encryption based on the selected encryption mode or do not
implement encryption.
This parameter specifies whether the alarm is enabled. An alarm is
generated only when the alarm is enabled and the alarm generating
conditions are met.
This parameter specifies whether the alarm is enabled. An alarm is
generated only when the alarm is enabled and the alarm generating
conditions are met.
Indicates whether to enable emergency power-off (EPO). EPO is
performed only when this parameter is enabled and the EPO switch is
triggered.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 User Interface
151