Table of Contents
Advertisement
This section describes the diagnostic program operation procedure.
Always switch OFF all devices before connecting or disconnecting
the E8000 EMULATOR and OTHER DEVICES. Failure to do so will
result in a FIRE HAZARD and will damage the E8000 emulator and
other devices, or will result in PERSONAL INJURY.
Notes: 1 . To execute the diagnostic program, DIAG.SYS must be installed in
flash memory, according to the instructions in the SH7410 E8000
Emulator User's Manual (HS7410EDD82HE).
2 . Before executing the diagnostic program, make sure the DIP switches
have the same settings as at shipment (refer to figure 4.1).
3 . When using the PCIF interface, execute the diagnostic program from
HDI.
1
2
3
Section 4 Procedures
WARNING
SW2
4
5
6
7
8
Figure 4.1
DIP Switch Setting at Shipment
SW1
1
2
3
4
11
5
6
7
8
Advertisement
Table of Contents
