Table of Contents
Advertisement
4.1
Installation Procedure
To execute the diagnostic program, file DIAG.SYS must be installed in the E8000 emulator flash
memory.
If the E8000 emulator is connected to the host computer via the bidirectional parallel interface, the
diagnostic program can be loaded with the following procedure. Note that the system disk is
assumed to be inserted in drive A of the host computer. It takes approximately one minute.
Operations
1. Initiate the E8000 system floppy
disk IPW.
2. Power on the E8000 emulator.
3. Emulator monitor command prompt
4. Enter F (RET) to initiate the flash
memory management tool. The
emulator displays prompt FM> and
waits for a flash memory
management tool command.
5. Enter SL (RET) to load the system
program.
6. Enter 1 (RET) to select PC as the
host computer type, and 2 (RET) to
select parallel interface as the
interface method.
7. Enter N (RET) to not load system
program E8000.SYS.
8. Enter N (RET) to not load
configuration file SHCNF741.SYS.
9. Enter N (RET) to not load firmware
file SHDCT741.SYS.
10. Enter N (RET) to not load the
ITRON debugger.
Display Message
START E8000
S:START E8000
F:FLASH MEMORY TOOL
L:SET LAN PARAMETER
T:START DIAGNOSTIC TEST
(S/F/L/T) ? _
(S/F/L/T) ? F (RET)
FM>
FM> SL (RET)
SELECT LOAD No. (1:PC or 2:WS) ? 1 (RET)
SELECT INTERFACE (1:RS-232C or 2:PARALLEL) ? 2 (RET)
LOAD E8000 SYSTEM FILE OK (Y/N) ? N (RET)
LOAD CONFIGURATION FILE OK (Y/N) ? N (RET)
LOAD FIRMWARE FILE OK (Y/N) ? N (RET)
LOAD ITRON DEBUGGER FILE OK (Y/N) ? N (RET)
12
Advertisement
Table of Contents
