Table of Contents
Advertisement
Test of E8000 Emulator, SH7410 Device Control Board, and SH7410 EV-Chip
Board (E8000 + EVCHIP):
The system configuration shown in figure 2.1 is used for testing the E8000 emulator, and the
SH7410 device control board and SH7410 EV-chip board for the E8000 emulator. The test results
are displayed on the personal computer display. After start-up, the system enters an endless test
loop without operator intervention until an error is detected. When an error occurs and ERROR
CONTINUE is not specified, the test is terminated. If ERROR CONTINUE is specified, the test
resumes execution after an error content display. When initiating the diagnostic program, select
whether to execute the following tests:
• Operation tests
• Serial interface test
• P1284 interface test
• LAN board (optional) test
Notes: 1 . When all test items are executed once, press the (CTRL) + C keys and
interrupt the test.
2 . The P1284 interface and serial interface tests require additional
circuits. Prepare the necessary circuits according to the diagrams in
section 6, Testing Circuits and Connectors, before selecting the P1284
interface and serial interface tests.
3 . The LAN board must be installed in the E8000 station and connected to
LAN when performing the LAN board (optional) test.
5
Advertisement
Table of Contents
