Table of Contents
Advertisement
Description:
(a) Enter the following command after the emulator monitor command prompt.
>a:TM.LOG (RET)
In the above example, a indicates drive a and TM.LOG indicates the file name.
Note: When selecting drive a, insert the floppy disk in the floppy disk drive
before executing this command.
(b) Execute the diagnostic program.
(c) Press the (CTRL) + C keys after executing the diagnostic program.
(d) Enter the following command to return to the monitor command input wait state.
> q (RET)
(e) Enter the following command in the monitor command input wait state to terminate data output
to the file.
>- (RET)
(f) Printing.
Open the file (TM.LOG) to which the diagnostic program execution results were output and
output the data to a printer from the personal computer used. If Windows3.1* is your personal
computer, open the file from Write in Accessories, and if Windows95* is your personal
computer, from Wordpad in Accessories.
Note: Windows3.1 and Windows95 are registered trademarks of Microsoft
Corporation.
10
Advertisement
Table of Contents
