Table of Contents
Advertisement
Test Condition Specifications
Please, key in TEST PARAMETER
OPERATION TEST EXECUTE (Y/N) ? N (RET)
ERROR CONTINUE (Y/N) ? N (RET)
TEST MODE SELECT
1. E8000 ONLY
2. E8000 + EVCHIP
3. E8000 + EVCHIP + FIXED USER
TEST MODE (1/2/3) ? 2 (RET)
DEVICE TYPE SH7410
RS232C LOOP CONNECTOR EXIST (Y/N) ? N (RET)
P1284 LOOP CONNECTOR EXIST (Y/N) ? N (RET)
OPTION LAN BOARD EXIST (Y/N) ? N (RET)
START (Y/N) ? Y (RET)
Description:
(a) Only for tests requiring operator intervention. Enter Y to execute the operation tests.
Otherwise, enter N.
(b) Y: Test continues when an error occurs.
N: Test stops when an error occurs.
(c) 1: Independent E8000 emulator system test
2: E8000 emulator, device control board, and EV-chip board test
3: E8000 emulator system test at shipment — cannot be used.
(d) Enter Y to execute the serial interface test. Otherwise, enter N.
(e) Enter Y to execute the bidirectional parallel interface test. Otherwise, enter N.
(f) Enter Y to execute the optional LAN board test. Otherwise, enter N.
(g) The test starts by entering Y. If N is entered, the diagnostic program main title will be
displayed again.
6. Execute the diagnostic program using the procedure shown in figure 3.1.
Execute each test item following the diagnostic program specifications. OK is displayed if a test
is executed with no errors. An example of the E8000 + EVCHIP test is shown on pages 18 to
20.
16
(a)
(b)
(c)
(d)
(e)
(f)
(g)
Advertisement
Table of Contents
