Table of Contents
Advertisement
Clutch control.
•
Press in the joystick – clutch engaged.
•
Release the lever – clutch disengaged.
HIGH/LOW SPEED
Gearshift handle
High speed mode, used in good driving
conditions, such as good weather and
stable ground. Otherwise use, low speed
mode. Pull the gear change handle back-
wards to activate, high speed mode.
Push forward to switch to, low speed mode.
Allow the engine to warm up before use. This
NOTE:
increases the service life of the equipment.
Avoid heavier loads until the equipment is
run in - after approx. 40-50 hours.
SWITCHING OFF THE ENGINE
1. Move the throttle to, slow mode
2. Allow the engine to idle for one/two minutes.
3. Turn the engine switch to the OFF position.
4. Pull the fuel valve lever to the OFF position.
16
GEAR LEVER
The gear lever has 4 positions: 3 forward speeds and
1 reverse for both high and low speed.
To change speed, move the gear lever to the desired
position. The lever is locked in place at each speed se-
lection.
Lower speeds are for heavier loads, while higher
speeds are for transporting light loads or an empty
container.
We recommend that you use a lower speed until you
are familiar with how the minidumper works.
If the engine slows during a load or the tracks slide,
select a lower gear.
Never use the choke to stop the engine.
Sudden stops at high speed under heavy load
are prohibited. Engine damage may occur.
To stop the engine in an emergency, turn the
engine switch to OFF.
Table of contents
Advertisement
Table of Contents
