2. LAMP AND LAMP HOUSE
About this chapter
This chapter describes how to remove and install the complete Lamp House. Furthermore, instructions on how to align the lamp to
maximize the light output are given.
Image 2-1
Overview
•
Removal of the Lamp House
•
Installation of the Lamp House
•
Realignment of the lamp in the Lamp House
2.1
Removal of the Lamp House
W
ARNING
Necessary tools
7 mm flat screwdriver
How to remove the Lamp House?
1. Switch off the projector and unplug the power cord at the projector back side.
2. Let the projector cool down for at least 15 minutes before proceeding to the next step.
Warning:
The Lamp House is very hot after operation. Let the projector cool down for at least 15 minutes before proceeding
to the next step. Failure to do so can cause serious injury.
3. Remove the right projector cover. See the installation manual of the projector.
4. Release the 3 captive screws on the Lamp House.
R5905109 LAMP HOUSE WITH 2.5 KW LAMP 21/09/2011
:
The procedures below may only be performed by Barco trained and qualified technicians.
2. Lamp and Lamp House
5