Table of Contents
Advertisement
5. Trouble Shooting
* The printer hardware problem can be solved by initializing through {Setting > System >
Initialize} of the function menu or by updating the firmware.
* Since the printing quality may change due to the printing condition or Cubicreator option
settings during the creation of G-Code, check the quality by using various printing conditions
or options.
If a problem occurs in the device, it is important to clearly identify the situation of the problem
occurrence. Store a modeling file (STL) or .cfb file, take a picture of the problem, or record the
video so that they can be referred during the customer support.
Defect of the Device
Filament Can't Be Dis c harge d through the Nozzle.
●
Check whether the filament is a genuine filament. Some filaments may cause a problem during
the extrusion due to their temperature condition that is different from the genuine filament or
severe deformation by the heat when they are used in Style Plus-A15, which may lead to the
breakdown of the Extruder.
will be exempted from the free warranty coverage.
●
Check whether the supply of the filament is smooth. If the filament is tangled or loosened in the
spool, the filament must be unwound and reorganized. Since the filament that has been tangled
or loosened once may continuously cause the problem, it is recommended to organize it for
certain.
●
A filament that has been polluted by humidity or dusts may have different characteristics
compared to the characteristics at the time of the initial opening. The use of such filament may
cause a breakdown such as clogging of the Extruder. Use the filament as fast as possible once it
is opened, and if it needs to be stored, block the humidity and dusts using vinyl while fixing it to
the spool so that it doesn't get loosened, and then store it for only a short period of time.
●
Check whether the filament that has been supplied is too thick or thin. Only a filament with
1.75mm of diameter must be used for Style Plus to ensure the accurate supply. If a thinner or
thicker filament is used, the device may break down as the filament gets jammed in the device
during the use.
●
In case the filament gets tangled in the Extruder or the jamming occurs, it would not be able to
extrude as a problem occurs on the extrusion. It must be used after removing the filament with
CUBICON Style Plus-A15 Series
T he breakdown of the printer due to the use of non-genuine filament
64
U ser Manual
Advertisement
Table of Contents
