Cubicon Style Plus-A15 Series User Manual page 15

③​ ​ R emove fixing tapes inside and outside of the product. (There may be tapes in places that are not shown in the
picture.)
④​ Remove extruder fixing straps (Cable Tie)​ –Remove fixing straps on the both side of the extruder by cutting
them with scissors.
​
B e cautious not to damage the product such as a driving belt when removing the fixing straps.
Remove the fixing strap in two locations marked in red in the drawing.
⑤​ ​ R emove a packing material for the heating bed at the bottom
​ L ift the heating bed and remove the packing material.
In case it is difficult to lift the heating bed manually, turn on the power and remove the packing material after
lifting the bed using the Motion function; Bed -> Up.
If the printer is operated without removing fixing strap (cable tie), fixing tape, or subsidiary packing, it
may cause a breakdown. Remove all the fixing items until none of them is left so that it would not cause
a problem in the operation of the printer.
CUBICON Style Plus-A15 Series​ ​
15
U ser Manual