Cubicon Style Plus-A15 Series User Manual page 4

Maintenance
Maintenance of the Extruder
Disassembly of the Extruder Module
Extruder(Management)
1. How to Maintain the Nozzle in a Good Condition
2. Cleaning the Inside of the Nozzle using the Loading
3. Cleaning the Inside of the Nozzle Using the Nozzle Management Pin
4. Cautions regarding the Use of the nozzle Management Pin
5. Cleaning the Outside of the nozzle
Replacing the Nozzle Kit of the Extruder Module
Maintenance of the Heating Bed
Replacing the Clean Filter
Update
Using a USB Memory Stick
Automatic Update
Trouble Shooting
Defect of the Device
Filament Can't Be Discharged through the Nozzle.
Data in a USB Drive Can't Be Viewed.
Data in a USB Drive Can't Be Printed.
When Printing, the Printing Doesn't Progress as Auto Leveling Fails.
The Function of Filament Existence Detection Sensor Doesn't Work Normally.
Filament Auto Loading Function Doesn't Work.
It Can't Recognize a Genuine Filament
Operation Gets Interrupted during Printing
Problems in the Printout and the Operation Errors
Network Connection Can't Be Made between Cubicreator and the Device
A Sculpture Doesn't Get Adhered to the Base (Heating Bed) and It Gets Taken Off.
The Part of a Sculpture, Mostly the Edge of the Base Gets Taken Off from the Bottom 68
Middle of a Sculpture Gets Cracked.
A Sculpture Can't Be Taken off from the Floor (Heating Bed).
Even though the Printing Is Completed, only a Part of a Sculpture Has Been Printed and
Some Parts Haven't Been Printed or Have Printed Abnormally.
Product Specifications
CUBICON Style Plus-A15 Series
4
U ser Manual
49
49
49
53
53
53
54
55
56
58
59
61
62
62
63
64
64
64
65
65
65
66
66
66
67
67
67
67
68
68
69
70