Table of Contents
Advertisement
which the auto leveling can be applied would be exposed, and calibrate the tilt offset as much as
the thickness of the tape.
●
Check whether a coating of the heating bed is damaged or it is severely bent. In such case, the
heating bed must be replaced. The heating bed is a consumable. Replace it though a warranty
service.
The Part of a Sculpture, Mostly the Edge of the Base Gets Taken Off from
the Bottom
Check the situation in
●
Taken Off,'
and take a necessary measure.
●
It can be partially improved through options such as the internal filling density during the creation
of the G-Code.
●
The contraction of the material that occurs in the printer that uses heat melting method is the
cause of it.
●
Either adjust the printing condition (internal temperature of the extruder, the heating bed, and the
printer) or use a material that contracts less. Even though the contraction can be improved by a
little according to the material, it is a natural phenomenon that occurs while the melted filament
gets solidified, and therefore, the most effective way is to revise a model to the shape that the
contraction can be enhanced.
Middle of a Sculpture Gets Cracked.
●
The contraction of the material that occurs in the printer that uses heat melting method is the
cause of it.
●
Either adjust the printing condition (internal temperature of the extruder, the heating bed, and the
printer) or use a material that contracts less. Even though the contraction can be improved by a
little according to the material, it is a natural phenomenon that occurs while the melted filament
gets solidified, and therefore, the most effective restraining method is to revise a model to the
shape that the contraction can be enhanced.
●
It can be partially improved through options such as the internal filling density during the creation
of the G-Code.
A Sculpture Can't Be Taken off from the Floor (Heating Bed).
●
Wait until the heating bed is sufficiently cooled down. If you take it off forcibly, it may damage the
heating bed.
●
As for the heating bed of Style Plus-A15, the sculpture is being attached on the floor during
printing, and it can be easily taken off when the heating bed cools down after printing. The
CUBICON Style Plus-A15 Series
'
' A Sculpture Doesn't Get Adhered to the Base (Heating Bed) and It Gets
68
U ser Manual
Advertisement
Table of Contents
