Cubicon Style Plus-A15 Series User Manual page 51

④ Open the Extruder cover (1), untighten the Extruder module
fixing bolt (2), and then close the Extruder cover (3).
Since the cable fixing bolts, the Extruder module fixing bolt, and
the cable fixing block must be used when assembling the
module, be sure to store them securely so that they don't get
lost.
⑤ The Extruder module can be separated from the printer by
pulling it up (2) after separating it from the fixing device at the
bottom of the Extruder by pushing it from the front of the printer
to the right (1). Be cautious not to damage the bar or the belt in
the main body of the printer during the disassembly.
Clean pollutants in the Extruder regularly.
* When opening the Extruder cover, the sculpture may get damaged as it collides with the
cover, if the sculpture is place under the cover. When opening the cover, check whether there
is any obstacle under the Extruder.
* When handling the Extruder cover, be cautious not to damage the wires inside of the device.
If the wires get damaged, it wouldn't operate properly and it would lead to the breakdown.
* Assembly/disassembly of the Extruder module must be performed only when the power of
the printer is turned
* If the assembly/disassembly must be performed while the temperature of the nozzle is high,
be cautious not to get a burn.
* Be cautious not to damage the parts in the Extruder part since they can be damaged if an
CUBICON Style Plus-A15 Series​ ​
off,​ and the temperature of the nozzle has been completely cooled down.
51
U ser Manual