Table of Contents
Advertisement
Since filament which is a material used in the printer has a risk of fire or injury, do not
attempt to heat it with other devices or deform it. Also handle it with care since there is a
risk of suffocation if the printout or the filament residue is swallowed.
Since there is a risk of fire/explosion if a volatile material is used in the printer, do not
use it. Also, since there is a risk of fire if ignitable substance or flammable substance is
left unattended around the printer, remove it.
Since a high intensity LED is used as an illumination LED, do not directly look at it in
order to protect your eyes.
Do not damage or deform the power or the cable of the printer, and do not supply power
that is outside of designated voltage.
When moving the printer, remove the power cord and cables while the main power is
turned off after the printer operation is stopped and the temperature of the internal parts
cools down sufficiently.
Since there is a risk of damage to the printer or fire, do not put a filament or any other
article in the empty space of the printer.
Do not turn off the power when the heating bed or the extruder is heated. Since a cooling
fan can't be operated, the device may break down or a fire may break out due to the high
temperature.
Since the printer uses a material after melting it, peculiar odor may be generated during
the process. Therefore, be sure to install the printer in a well ventilated place.
Do not install the printer outdoor or in a place under direct sunlight or a place with a lot
of vibration, humidity, and dust.
Do not install the printer on an unstable place such as vibrating or uneven place.
Also, remove any article around the printer which can be damaged by the heat or the
vibration during the operation of the printer.
If filaments or parts that are not supplied by our company are used in the printer, it may
cause damage to the product, or the quality can't be assured. The problem that has
occurred due to it is exempted from the free warranty coverage.
Do not arbitrarily disassemble or modify the printer on user's own beside the parts that
have been approved in the user manual. Failure to comply may cause an injury or
damage to the printer, and the problem that has occurred in such case is exempted from
the free
warranty
c overage.
CUBICON Style Plus-A15 Series
7
U ser Manual
Advertisement
Table of Contents
