Table of Contents
Advertisement
Y35 HD v3
User Manual & Install Guide
4 Basic System Quick Start
Your Y35 HD v3 will have already come pre-configured by Gatekeeper Systems with the most common
default settings which are applicable to most deployments – and you will only need to verify and adjust
the basic settings to get up and running. The following sections will guide you through the basic setup
process so that you can begin using your new product as soon as possible.
4.1 Step 1: Powering Up the Y35 HD v3
The Gatekeeper Project Team are able to mount and install the device into the vehicle based on your
requirements and in accordance with industry best practices from years of experience. If you prefer to
mount the device yourself, please read
Chapter 9
for detailed hardware installation instructions.
Turning your vehicle ignition on will automatically power up the Y35 HD v3. When your vehicle ignition
is turned off, the device will automatically shut down after 10 minutes (you will be able to change this
later in the device settings).
4.2 Step 2: Connecting your Navigation Device
Once the device has powered up, please verify that you can see the display on your LCD monitor or
ICD2 with live video from connected cameras shown.
Figure 4-1 Live Camera View Shown on Device Startup
You may now use the supplied navigation device (Remote Control, Finger Mouse, G4 Connect or ICD2)
to perform the rest of the basic setup process. For more details on connecting and using the navigation
devices, please read
Section 3.1
and
Section
3.2.
34 of 156
Advertisement
Table of Contents
