Table of Contents
Advertisement
Y35 HD v3
User Manual & Install Guide
camera. This will switch the display to Single Camera On-screen View to display the video from
the selected camera.
Alternatively, with the Finger Mouse or the ICD2, you could also click on any video stream on
▪
the (2x2) grid display to immediately jump to that channel and display the video from the
corresponding camera. This will switch the display to Single Camera On-screen View to display
the video from the selected camera.
Once you have selected a channel to view, you can cycle through the available channels
▪
iteratively in quad grid display mode by pressing the key zero [0] on the ICD2.
9 Camera On-screen View
In 9 Camera On-screen View mode, the screen is split into nine sections (using a 3x3 grid layout)
▪
and video from all connected cameras is simultaneously shown on the screen. Note: all other
areas will display a black box.
In order to select a specific camera for viewing, you may press any of the keys [1-5] on the ICD2
▪
to immediately jump to that channel and display the video stream from the corresponding
camera. This will switch the display to Single Camera On-screen View to display the video from
the selected camera.
Alternatively, with the Finger Mouse or the ICD2, you could also click on any video stream on
▪
the quad grid display to immediately jump to that channel and display the video from the
corresponding camera. This will switch the display to Single Camera On-screen View to display
the video from the selected camera.
Notes
Channels which do not have cameras configured on them will just show a black display.
▪
Any channel which is configured with a camera, but is not receiving any video signal
▪
from that camera will show a Video Loss message on the screen.
Figure 3-7 Example of Video Loss
27 of 156
Advertisement
Table of Contents
