Guide To Common Navigation Actions; Figure 3-4 Connecting The Icd2 - Gatekeeper Y35 HD v3 User Manual & Installation Manuallines

Y35 HD v3 User Manual & Install Guide
When viewing video streams, pressing any button (from 1-9) will immediately jump
to the video stream from the corresponding camera. Pressing the button zero (0) will
cycle through the camera channels.
How to Connect the ICD2
If using an ICD2 (CP4), you must first configure the DVR for it. First, plug the 4-Pin Female Aviation end
of (CAB000390) into the A/V output on the back of the unit also 4-Pin Male Aviation. Next connect the
3-pin connector on CAB000390 to the 3-pin connector on CAB000376 (Serial/Sensor cable), and connect
the ICD2 connector cable (CAB000391) to CAB000390 and to the ICD2. Using the remote or mouse, log
into the Y35 HD v3 and under: Setup -> Collection -> Serial Port -> RS232, set this connection to CP4
and ensure Baud is set to 57600, hit apply and then restart the unit. Note that you cannot connect a
Driver Alert button and an ICD2 at the same time.

3.2 Guide to Common Navigation Actions

The following table provides a summary of commonly used navigation functions.
No. Action
1 Navigating through
the screens.
2 Selecting an item on
the screen.
Note: Also referred to
as clicking the item.

Figure 3-4 Connecting the ICD2

IR Remote
Use the Arrow Keys to
move the cursor to
highlight different
menu options.
Move the cursor using
Arrow Keys until the
desired item is
highlighted, then press
the Enter Key to select
it.
v3
Finger Mouse
Move the on-screen
pointer using the Track
Ball and point to the
desired menu option.
Move the on-screen
pointer until it points to
the desired item, then
click the Trigger Button
to select it.
ICD2
Use your finger to tap
the desired menu
option.
Tapping on the desired
item with your finger
will select it.
21 of 156