Table of Contents
Advertisement
Y35 HD v3
User Manual & Install Guide
Trigger
Linkage
Event
▪
Click the (Setup) button under Trigger to
display the Trigger setup screen for the
associated IO input line.
This will display a drop list which allows you to
select the trigger for this IO input line:
Low (0V)
▪
High (12V – 24V)
▪
DEFAULT SETTINGS:
By default, all the IO line triggers will be set to
High. However, please adjust any or all of these
values as appropriate, as whether the trigger
value is High or Low will depend on the vehicle
and the wiring.
Debounce Time
DEFAULT SETTINGS:
10 Seconds
▪
Click the (Setup) button under Linkage to go
to the Linkage setup screen. This sets up the
video display, recording and snapshot options
associated with this alarm.
The Linkage setup screen enables you to
configure the following options:
Channel – checkboxes which allow you
▪
to select any combination of the
camera channels to be included in the
display and recording.
Pre Recording – numeric value box
▪
which allows you to enter the duration
for which video will be recorded prior
to the alarm being triggered.
Post Recording – numeric value box
▪
which allows you to enter the duration
for which video will continue to be
recorded when the alarm is triggered.
Lock – checkbox, if selected will mark
▪
the recorded video associated with this
alarm as locked video.
Linkage IO Output – checkboxes, if
▪
enabled, the device will send a signal
to the selected IO output lines.
110 of 156
Advertisement
Table of Contents
