Table of Contents
Advertisement
Y35 HD v3
User Manual & Install Guide
Snap
Post Recording – numeric value box
▪
which allows you to enter the duration
for which video will continue to be
recorded when the alarm is triggered.
Lock – checkbox, if selected will mark
▪
the recorded video associated with this
alarm as locked video.
Linkage IO Output – checkboxes, if
▪
enabled, the device will send a signal
to the selected IO output lines.
Output Delay Time – numeric text
▪
field to set the delay time for the IO
output (in seconds).
Linkage Screen – drop list to select the
▪
options to display the video from the
selected cameras on-screen when the
alarm occurs.
Alarm Image Upload – checkbox, if
▪
selected will enable the device to
upload the alarm to the center server.
Adkit Voice: Unselected- if selected,
▪
the device will play an mp3 recording
when alarm is triggered to alert the
driver.
Click the (Setup) button under Snap to display
the Snap setup screen. This sets up the
snapshot options associated with this alarm.
The Snap setup screen enables you to
configure the following options:
Snap Mode – drop list to select the
•
number of snapshots taken when the
alarm is first triggered. (Single or
Many).
Number of Snaps – drop list to select
•
the total number of snapshots
captured when the alarm is triggered.
Snap Interval – numeric text field to
•
set the time (in milliseconds) between
snapshots taken when the alarm is
triggered.
Enable – checkbox – if selected, these
•
channels will have a snapshot taken of
them.
FTP – checkbox – if selected, will
•
allow the snapshots taken of the
channel to be transferred remotely.
131 of 156
Advertisement
Table of Contents
