Table of Contents
Advertisement
ELECTRO FREEZE Model CS600
7.2
Disassembly Instructions
HANDLE -
DISPENSE
KNOB -
HAND
Figure 7-2
Figure 7-3
Figure 7-4
10
ROD - PLUNGER
PLUNGER
O-RING - PLUNGER
O-RING - HEAD
DISPENSE - HEAD
PIN - HANDLE
NOZZLE
INSERT-ASSY . MIX FEED
O-RING
1
2
O-RING
3
TUBE-MIX
4
FEED
CAUTION
To avoid electrical shock or
contact with moving parts, make
sure all switches are in the
"OFF" position and that the main
power supply is disconnected.
It is important that the freezer be disas-
sembled, washed, lubricated and sani-
tized before operation.
NOTE: If there is product in the
freezer, refer to Section 10, Closing
Procedures, 10.1 Draining Product.
1. Remove plunger rod (4, figure 7-2),
hand knobs (8) and pull dispensing head (1)
straight out.
2. Remove the handle pin (7), plunger
(5) and nozzle (9) from head (1).
3. Remove O-ring (figure 7-2, 2) from
head (1). Remove O-rings (3) from plunger
(5).
4. Remove the beater shaft assembly
(2, figure 7-3) from the cylinder. Then remove
breaker bar (1), scraper blades (3) and shaft
seal (4,5) from the beater shafts. Remove
the cup seals (4) from the washer (5) on the
shaft seal assembly.
5. Remove hopper cover, drip tray and
insert.
6. Remove the mix feed tube (figure 7-
4) and mix float from the hopper. Remove
insert (2) from mix feed tube.
CAUTION
To prevent bacteria growth,
remove all O-rings when
cleaning. Failure to do so
could create a health hazard.
7. Remove O-rings (3) from mix feed
tube (4). Remove O-ring (7) from insert (2).
184596
Advertisement
Chapters
Table of Contents
