Table of Contents
Advertisement
ELECTRO FREEZE Shake Model CS600
13 Troubleshooting Tables
PROBLEM
Unit does not
1.
Freezer unplugged.
operate.
2.
Fuse blown or breaker tripped at main
disconnect.
3.
Actuator rod not installed
4.
Off on high pressure cut-out control.
5.
Circuit breaker tripped.
6.
Faulty selector switch
7.
Disconnected or broken wire in electrical
circuit.
Mix leaking at
1.
Faulty o-ring.
dispensing
head.
2.
Head not properly installed.
Leakage of mix
1.
or water from
drain tube to
drip tray.
2.
3.
Product
1.
dispenses slowly
out of dispensing
head.
24
PROBABLE CAUSE
Damaged beater shaft seal or installed
improperly.
Beater shaft pitted or damaged where
o-ring rides.
Beater shaft end play not set properly.
Product too cold.
- continued
1.
Plug in freezer.
2.
Make sure your freezer is connected to a
separate circuit independent from any other
electrical equipment. Have technician check
fuse or breaker size and check for low
voltage; if not within 10% of nameplate
rating call power company.
3.
Install actuator rod.
4.
Water turned off or defective water
regulating valve. Check water suppy.
5.
Contact your Electro Freeze distributor for
service.
6.
Contact your Electro Freeze distributor for
service.
7.
Contact your Electro Freeze distributor for
service.
1.
Replace o-ring.
2.
Install head properly. Replace o-ring if
pinched.
1.
Replace cup seals on washer. Install
properly.
2.
Replace beater shaft.
3.
Contact your Electro Freeze distributor for
service.
1.
See Dispensed Product Too Hard.
REMEDY
184596
Advertisement
Chapters
Table of Contents
