Soft Serve Information; 11.1 Overrun; 10.2 Rerun - H.C Duke & Son Electro Freeze COMPACT Series Operator's Manual

Soft serve freezer
Table of Contents

Advertisement

ELECTRO FREEZE Model CS600
11

Soft Serve Information

11.1 Overrun

As mix is frozen in the freezing cylinder,
air is incorporated into the mix to in-
crease its volume, as well as enhance
the taste and texture of the finished
product. The increase in volume is
called overrun. Fifty percent overrun
translates to a volume increase of 50
percent — 10 gallons of liquid mix has
become 15 gallons of finished product.
Controlled overrun is important to
maintain consistency in product quality.
Too much overrun (air) results in a light,
fluffy product lacking the cold refreshing
appeal of a quality product. Too little
overrun results in a wet, heavy product.
To correctly measure the overrun per-
form the following steps:
the scale* and adjust your scale to zero.
and fill the container with liquid product
to the top. Weigh container and record.

10.2 Rerun

If local health codes permit the use of
rerun make sure to follow these proce-
dures:
tized container.
below 40
rerun. Always skim off and discard foam.
Then combine the rerun with fresh mix
in a ratio of 50/50 and add to the hopper
during operation.
as possible and discard after closing.
This will break the rerun cycle and
reduce the possibility of high bacteria
and coliform counts.
184596
1. Place an empty pint container on
2. Remove container from scale
1. Store rerun mix in a clean, sani-
2. Store in a cooler with a temperature
º
F (4.4
º
C).
3. DO NOT prime the machine with
4. Once a week run the mix as low
3. Replace liquid product with
frozen product, being sure to leave no
voids or air spaces in the container.
4. Strike off the excess product so it
is even with the top of the container and
measure the weight.
5. Use the following formula to figure
overrun percentage:
"Weight of liquid mix minus weight of frozen
product/divided by the frozen weight.
Multiply by 100." See example.
Example:
Weight of 1 pint of mix
Weight of 1
pint frozen product
Difference
6 oz. divided by 12 oz. = .5
.5 x 100 = 50% overrun
*Your Electro Freeze Distributor can
provide a scale (P/N HC158049) that is
graduated in overrun percentage.
NOTE: Rerun product is unable to
accept the same amount of air as
fresh product. As a result, the quality
will be affected and product may
appear grainy and icy.
For further information contact your local
Electro Freeze distributor or the Service
Department of H. C. Duke & Son, LLC,
phone (309) 755-4553 or (800) 755-4545.
= 18 oz.
=
12 oz.
=
6 oz.
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Electro freeze compact cs600

Table of Contents