Table of Contents
Advertisement
ELECTRO FREEZE Model CS600
6
Operator Controls –
6.4
Mix Float
When this float is mounted on the float
stem inside the hopper it automatically
senses the mix level. It activates the "Add
Mix" light
6.5
Mix Feed Tube & Insert
Figure 6-3
Pin
Location
Figure 6-4
8
(not shown)
Insert-Assy.
Miix Feed
Pin
Location
continued
This two-position regulating device
(figure 6-3) meters the correct amount
of mix and air into the freezing cylinder.
a. "OPEN" - Always use this position
when dispensing product. (See figure 6-4.
When OPEN you can see clear through the
hole in the top of mix feed tube.)
Important:
If product is dispensed when the
regulator is in the "CLOSED" posi-
tion, a freeze-up will occur and may
damage the freezer.
b. "CLOSED" - Use this position
when the freezer is in the "NIGHT"
mode, and when product will not be
dispensed for a long period of time.
(See figure 6-4. When CLOSED you
cannot see through the hole in the top
of the mix feed tube — the white plastic
insert tube inside will block the hole.)
184596
Advertisement
Chapters
Table of Contents
