Other Remote Networks - Omron SYSMAC CS1W-CLK11 Operation Manual

Remote Programming and Monitoring
CX-Programmer
CX-Programmer
Note
7-2-3

Other Remote Networks

SYSMAC Support Software or CV Support Software
SYSMAC Support
Software (CVM1 Only)
or
CV Support Software
CX-Programmer
182
Programming Device
Controller Link Network
CS/CJ-series, C200HX/HG/
HE, CVM1, CV-series, or
CQM1H-series PC
Controller Link Network
Controller Link
Support Software
Note Remote programming and monitoring is possible from computer nodes.
1. Version 1.20 of CX-Programmer must be used for the CQM1H-series Con-
troller Link Unit.
2. Use CX-Programmer version 2.04 or later for a CJ-series Controller Link
Unit.
A Programming Device connected to a CVM1 or CV-series CPU Unit can pro-
gram and monitor a CVM1 or CV-series PC on a different type of network
(SYSMAC NET or SYSMAC LINK) through a CVM1 or CV-series PC. Other
types of PC cannot be programmed or monitored on remote networks.
Programming Device
CVM1 or CV-series PC
Controller Link Network
Controller Link
Support Software
Note
Remote programming and monitoring is not possible from computer nodes.
Computer nodes can only monitor Controller Link Network status.
A Programming Device connected to a C200HX/HG/HE PC cannot remotely
program or monitor a node on a remote network.
A CX-Programmer connected to a CS/CJ-series, C200HX/HG/HE, CVM1,
CV-series, or CQM1H-series CPU Unit can program and monitor any other
PC on a different type of network (Ethernet, SYSMAC NET, or SYSMAC
LINK) through a CS/CJ-series, CVM1, or CV-series PC.
Controller Link Network
CVM1 or
CV-series PC
Controller Link Network
CS/CJ-series,
CVM1, or CV-
series PC
Controller Link Network
CVM1 or CV-series PC
SYSMAC NET
CVM1 or CV-
series PC
Section 7-2
Programming
and monitoring
CS/CJ-series, C200HX/HG/
HE, CVM1, CV-series, or
CQM1H-series PC
CS1-series PC
Controller Link Network
Programming
and monitoring
CVM1 or CV-series PC