6Hqg5Hfhlyh 'Dwd $Uhdv - Omron SYSMAC CS1W-CLK11 Operation Manual

Introduction
6-1-3 Send/Receive Data Areas
CS/CJ-series PCs
File Memory
Forced set/reset
For details on commands for CS/CJ-series PCs, refer to the CS/CJ-series
Programmable Controllers Programming Manual (W340). For details on com-
mands for CVM1 and CV-series PCs, refer to the FINS Commands Reference
Manual (W227). For details on commands for C200HX/HG/HE PCs, refer to 6-
6 Commands and Responses for C200HX/HG/HE and CQM1H-series PCs.
For details on commands for Controller Link Units, refer to 6-5 Commands
and Responses for Controller Link Units.
The data areas that can be used as operands in the SEND and RECV instruc-
tions depend on the PC, as shown in the following tables. Be sure to set the
operands so that the end of the data area is not exceeded.
CIO (IR etc.)
Work Area (WR)
Holding Area
Auxiliary Area
Timer
Counter
Data Memory
Extended Data Memory
Note 1. Writing is not possible to words A000 through A447 in the Auxiliary Area.
2. A maximum of thirteen banks can be used for Expansion DM. For details
on extended data memory and the number of banks, refer to the operation
manual for the PC model that is being used.
Type of command
FILE NAME READ
SINGLE FILE READ
SINGLE FILE WRITE
MEMORY CARD FORMAT
FILE DELETE
VOLUME LABEL CREATE/
DELETE
FILE COPY
FILE NAME CHANGE
FILE DATA CHECK
MEMORY AREA FILE
TRANSFER
PARAMETER AREA FILE
TRANSFER
PROGRAM AREA FILE
TRANSFER
FORCED SET/RESET
FORCED SET/RESET
CANCEL
Area
CIO 0000 to CIO 6143
W000 to W511
HR000 to HR511
AR000 to AR959 (See note 1.)
T0000 to T4095
C0000 to C4095
DM00000 to DM32767
EM00000 to EM32767 (See note 2.)
Section 6-1
Code CS/ CVM1/
CJ CV
2201 Yes Yes
2202 Yes Yes
2203 Yes Yes
2204 Yes Yes
2205 Yes Yes
2206 No Yes
2207 Yes Yes
2208 Yes Yes
2209 No Yes
220A Yes Yes
220B Yes Yes
220C Yes Yes
2301 Yes Yes
2302 Yes Yes
Range
127