Connecting To The Console And Auxiliary Ports; Connecting To The Console Port; Connecting To A Csu/Dsu - Cisco AS5350 Installation Manual

Chapter 3 Installing the Cisco AS5350
•
Figure 3-12 Connecting to a CSU/DSU

Connecting to the Console and Auxiliary Ports

Use the console terminal for local administrative access to the universal gateway. You can only connect
a terminal to the console port. You can use the auxiliary port to connect a terminal or a modem for remote
access to the universal gateway.

Connecting to the Console Port

To connect a terminal (an ASCII terminal or a PC running terminal emulation software) to the console
port on the Cisco AS5350, follow this procedure:
Step 1 Connect the terminal to the console port using an RJ-45 rollover cable and an RJ-45-to-DB-25 or
RJ-45-to-DB-9 adapter. The adapters provided are labeled TERMINAL. The adapters and the rollover
cable are included in the accessory kit that comes with the universal gateway. (See Figure 3-13.)
Note
Step 2 Configure your terminal or PC terminal emulation software for 9600 baud, 8 data bits, no parity, and
2 stop bits.
Step 3 Configure the console port. See the Cisco AS5350 and Cisco AS5400 Universal Gateway Software
Configuration Guide. This document is available on the World Wide Web and the documentation
CD-ROM that comes with your universal gateway. (See the "Obtaining Documentation" section on
page xiii.)
78-10754-03 0A
Connect a synchronous serial port to a modem or a CSU/DSU with a serial transition cable. (See
Figure 3-12.)
Synchronous serial
port (DB-26)
Serial
transition
cable
EIA/TIA-232, EIA/TIA-449, EIA/TIA-530A,
EIA/TIA-530, V.35, or X.21 connector
For additional information on rollover cable pinouts, see Appendix C, "Cabling Specifications."

Connecting to the Console and Auxiliary Ports

CSU/DSU or
other DCE or DTE
Cisco AS5350 Universal Gateway Chassis Installation Guide
Internet
3-11