Assembly 5.1 Unpacking; Required Tools - Bosch ZEMO SU-E FS 12 Translation Of Original Operating Instructions

5 Assembly
WARNING
!
Risk of eye injury
Problems may arise if components are set
incorrectly. They may cause serious injuries to
the face.
 Always wear safety glasses to protect eyes
when assembling pedelecs.
CAUTION
!
Crash and crushing hazard caused by
unintentional activation
There is a risk of injury if the electric drive system
is activated unintentionally.
 Remove the battery.

Assemble the pedelec in a clean, dry
environment.

The Work environment
between 15 °C and 25 °C.

The fitting stand used must be approved for a
maximum weight of least 30 kg.
5.1 Unpacking
The packaging material consists mainly of
cardboard and plastic film.
 Dispose of the packaging in accordance with
the regulatory requirements (see Section 10).
 Pedelecs are fully assembled in the factory for
test purposes and then dismantled for
transportation. The pedelec is 95% to 98% pre-
assembled.
MY22Z01 - 12_1.0_25.07.2022
temperature should be
Scope of delivery
 1 pre-assembled pedelec
 1 front wheel

2 pedals
 2 quick releases (optional)

1 charger
 1 set of operating instructions on CD

1 battery (supplied separately from the pedelec)
5.2

Required tools

The following tools are required to assemble the
pedelec:
Knife
Ring spanners
8 mm, 9 mm, 10 mm, 13 mm, 14 mm and 15 mm
Torque wrench
Working range 5... 40 Nm
by.schulz handlebars:
TORX® bits: T50, T55, and T60
Hex key
2 mm, 2.5 mm, 3 mm, 4 mm, 5 mm, 6 mm and
8 mm
Cross-recess screwdriver
Slotted-head screwdriver
Table 38: Tools required for assembly
Assembly
68