System Message - Bosch ZEMO SU-E FS 12 Translation Of Original Operating Instructions

Applies only to eShift with SHIMANO DI2
automatic hub gears
Display Change
Gear adjustment You can use this menu option to
make a fine adjustment to the
SHIMANO DI2. You'll find the speci-
fied setting range described in the
gear manufacturer's operating
instructions. Make fine adjustments
if the gear shift makes unusual
noises. This menu option is only
shown when the on-board computer
is positioned in its mount.
Gear recovery You can use this menu option to
reset the rear derailleur if it has
been detached – due to a crash or
impact against the derailleur, for
example. You will find a description
of how to reset the gear shift in the
gear shift manufacturer's operating
instructions. This menu option is
only shown when the on-board
computer is positioned in its mount.
Gear vx.x.x.x: this is the gear software version.
This menu option is only shown
when the on-board computer is
positioned in its mount. This menu
option is only shown if you have an
electronic control gear.
Table 25: Changing the system settings
Applies only to eShift with NuVinci HISync/
ENVIOLO with Optimized HISync
Display Change
Gear calibration
adjustable gear is calibrated. You
might need to perform calibration
while riding in the event of a fault.
The menu option is only shown
when the on-board computer is
positioned in its mount.
 Press on the Lighting button
 Follow the instructions.
Gear vx.x.x.x:
This menu option is only shown
when the on-board computer is
positioned in its mount. This menu
option is only shown if you have
an electronic control gear.
Table 26: Changing the system settings
MY22Z01 - 12_1.0_25.07.2022
This is where the continuously
to confirm calibration.
this is the gear software version.
Applies only to eShift with ROHLOFF E-14
Speedhub 500/14
Display
Start gear
Gear vx.x.x.x:
Table 27: Changing the system settings

3.4.2.12 System message

The drive system monitors itself continuously and
if an error is detected, it is indicated by a system
message. The system may switch off
automatically depending on the type of error. You
will find more information and a table containing
all system messages in Section 6.2.
Description
Change
This is where you can set the start
gear. The automatic gear switch
function is switched off in Position
– –. This menu option is only
shown when the on-board
computer is positioned in its
mount.
this is the gear software version.
This menu option is only shown
when the on-board computer is
positioned in its mount. This menu
option is only shown if you have
an electronic control gear.
51