Bosch ZEMO SU-E FS 12 Translation Of Original Operating Instructions page 196

8.5.9.2 Inspecting and greasing BY.SCHULZ
suspension seat post
Only applies to pedelecs with this equipment
1 Remove seat post from the frame.
2 Remove safety and protective cover.
3 Clean seat post on the inside and outside.
4 Examine seat post rack for scratches, cracks
and breaks.
 Replaced damaged seat post as specified in
the parts list.
5 Lubricate screws in the parallel suspension.
6 Reinsert seat post as per height specifications
in the pedelec pass. Check screws for correct
tightening torques.
Torques G1

M8 seat clamp screw
M5 fixing grub screws
Torque G2

M6 seat clamp screw
M5 fixing grub screws
7 Put on safety and protective cover.
MY22Z01 - 12_1.0_25.07.2022
8.5.9.3 Inspecting and greasing RS SUNTOUR
Only applies to pedelecs with this equipment
1 Remove seat post from the frame.
2 Remove safety and protective cover.
3 Examine seat post rack for scratches, cracks
and breaks.
 Replaced damaged seat post as specified in
the parts list.
 If the paint protection film protecting a child
seat is missing or has worn away, affix a new
paint protection film.
4 Undo pre-tensioning adjuster and take out
steel spring.
5 Clean seat post on inside and outside.
6 Grease seat post on inside with SR SUNTOUR
20 ... 24 Nm
3 Nm
grease no. 9170-001.
7 Lubricate pressure roller with bicycle chain oil.
12 ... 14 Nm
 Lubricate articulated joints in parallel
3 Nm
suspension with bike chain oil.
Figure 200: SR SUNTOUR suspension seat post
lubrication points
8 Reinsert seat post as per height specifications
in the pedelec pass.
9 Check screws for correct tightening torques.
SR SUNTOUR suspension seat post
torques

Seat clamp screw
M5 fixing grub screws
10 Put on safety and protective cover.
Inspection and maintenance
suspension seat post
1
15–18 Nm
3 Nm
195