Preparing The Battery; Retrofitting The Powertube Adapter - Bosch ZEMO SU-E FS 12 Translation Of Original Operating Instructions

5.3.2

Preparing the battery

5.3.2.1 Retrofitting the PowerTube adapter

Only applies to pedelecs with this equipment
The PowerTube Adapter 400 or 500 needs to be
altered to use the BOSCH PowerTube 625 battery
mount.
1 Use a TORX® T25 wrench to undo the screws
in the battery mount.
Figure 51: Undoing screws on battery mount
2 Use ratchet to remove the two 4 mm hexagon
screws from the PowerTube adapter. You can
use a hexagonal key to remove the screws if
you don't have a small ratchet.
Figure 52: Removing the 4 mm hexagon screws
3 Use ratchet to remove the two 4 mm hexagon
screws from the PowerTube adapter.
Figure 53: Removing hexagon screws
4 Remove the PowerTube adapter.
MY22Z01 - 12_1.0_25.07.2022
Figure 54: Pulling out the PowerTube adapter
5 Use adapter plates to adjust the distance if
necessary.
.
Figure 55: Fitted adapter plates
6 Use a TORX® T25 wrench to fasten the screws
into the battery mount.
.
Figure 56: Fastening the battery mount
Assembly
70