Manual Client Configuration - Linksys SPA9000 Administrator's Manual

Advanced Methods of Configuration
Figure 2-20 Unprovisioned Client Station Acquiring a Configuration Profile
/spa$PSN.cfg
To add a new IP phone to the SPA9000, connect the IP phone to the QoS switch to which the SPA9000
is connected and power on the unit.
To add a previously-used IP phone to the SPA9000, perform the following steps:
1.
2.
3.
4.
The SPA9000 provisions only the necessary parameters to the client stations. It assumes the rest of the
parameters have appropriate values, which are either the default values or manually configured values.
For example, the SPA9000 provisions only Extension 1 on the client stations. Access the administration
web server using the Administrator account to manually configure other extensions on specific client
stations.

Manual Client Configuration

The client stations can also be manually configured with the contents of the profile served by the
SPA9000.
The following XML file is served by the SPA9000 when a client station requests /spa$PSN.cfg
<flat-profile>
<Resync_Periodic>1</Resync_Periodic>
<Profile_Rule>tftp://spa-9000-ip-address:69/cfg/init_$MA.xml</Profile_Rule>
</flat-profile>
The following XML file is served by the SPA9000 when client station requests /cfg/init_$MA.xml:
<flat-profile>
<User_ID_1_>next-available-user-id</User_ID_1_>
<Extension_1_>1</Extension_1_>
<Short_Name_1_>next-available-user-id</Short_Name_1>
Linksys SPA9000 Administrator Guide
2-28
Yes
Request
/cfg/init_$MA.xml
Upgrade the IP phone with SPA9000-compatible firmware.
Factory reset the unit.
Power cycle the unit.
Connect the unit to the switch.
DHCP
No
Option 66?
Request
Request
/cfg/generic.xml
Chapter 2 Getting Started
Look For
Config Server
Document Version 3.01