Linksys SPA9000 Administrator's Manual page 46

Initial Setup and Configuration
4.
To use Static IP, type the static IP address, type the default router address (in the Gateway field),
and type the addresses of the primary and secondary DNS servers.
The Secondary DNS server is optional when using static IP addressing.
5.
Click Submit on Page 6.
Step 6
Complete the following steps, as described on Page 7 and Page 8 of the wizard:
1.
Check the firmware version.
a.
Plug an analog phone into the Phone 1 port of the SPA9000.
b. Pick up the analog phone and enter **** on the phone keypad to access the IVR menu.
c. Press 150# to hear the firmware version.
2.
Enable web access.
a.
Enter 7932# on the phone keypad.
This allows you to enable or disable the administration web server on the SPA9000.
b. Press 1#.
This enables the administration web server.
3.
Press Next on Page 7.
4.
If it has been used before, reset the SPA9000 to the factory defaults:
a.
On the keypad of the analog phone, press 73738#.
This allows you to reset the unit to its factory default.
b. Press 1 on the keypad.
5.
If it has been used before, reset each SPA900 series IP phone to its factory defaults.
a.
Press the Menu button on the SPA900 series phone.
b. Use the Navigate button to scroll down to Factory Reset.
(or press Menu, type 14, and click OK).
c. Click Select.
Note
6.
Press Next on Page 8.
The system displays Page 9, shown in
Linksys SPA9000 Administrator Guide
2-16
To reset a SPA901 phone press **** on the SPA901 keypad, press 73738#, and then press 1.
Figure 2-9.
Chapter 2 Getting Started
Document Version 3.01