Linksys SPA9000 Administrator's Manual page 41

Chapter 2 Getting Started
Table 2-2 IVR Options (continued)
Set Primary DNS Server
Check administration web
server port
Check LAN IP Address
Check PBX multicast
address
Set PBX multicast
address
Enable/Disable
administration web server
Manual Reboot of Unit
User Factory Reset of
Unit
WARNING:
ALL "User-Changeable"
NON-DEFAULT
SETTINGS WILL BE
LOST!
This might include
network and service
provider data.
Factory Reset of Unit
WARNING:
ALL NON-DEFAULT
SETTINGS WILL BE
LOST!
This includes network and
service provider data.
Note
The items marked with "Requires Password" only require a password if the Administrator password is
set.
Document Version 3.01
161 Enter IP address using
numbers on the telephone
key pad. Use the * (star) key
when entering a decimal
point.
170 None
210 None
180 None
181 Enter IP address and port.
Use * key for entering a dot.
For example,
224.168.168.169:8089 is
224*168*168*169*8089.
7932 Enter 1 to enable
Enter 0 to disable
732668 None
877778 Enter 1 to confirm
Enter *(star) to cancel
operation
73738 Enter 1 to confirm
Enter * (star) to cancel
operation
Using the Interactive Voice Response Interface
Requires password
IVR announces the port that the web
server is listening on. (Default is 80)
IVR announces the current IP address of
the LAN port.
IVR announces the current value.
Enter a * between the IP address and the
Port fields. Requires Password
Requires password
After you hear "Option Successful," hang
up. Unit reboots automatically.
SPA prompts for confirmation. After
confirming, you hear "Option
Successful." Hang up. Unit reboots and
all "User Changeable" configuration
parameters are reset to factory default
values.
SPA prompts for confirmation. After
confirming, you hear "Option
Successful." Hang up. Unit reboots and
all configuration parameters are reset to
factory default values.
Linksys SPA9000 Administrator Guide
2-11