Control Timer Values (Sec) - Linksys SPA9000 Administrator's Manual

Regional Tab

Control Timer Values (sec)

Field
Hook Flash Timer Min
Hook Flash Timer Max
Callee On Hook Delay
Reorder Delay
Call Back Expires
Call Back Retry Intvl
Call Back Delay
VMWI Refresh Intvl
Interdigit Long Timer
Interdigit Short Timer
Linksys SPA9000 Administrator Guide
6-28
Description
Minimum on-hook time before off-hook qualifies as hook-flash. Less than this the
on-hook event is ignored. Range: 0.1–0.4 seconds.
The default is 0.1.
Maximum on-hook time before off-hook qualifies as hook-flash. More than this the
on-hook event is treated as on-hook (no hook-flash event). Range: 0.4–1.6 seconds.
The default is 0.9.
Phone must be on-hook for at this time in sec before the SPA9000 will tear down the
current inbound call. It does not apply to outbound calls. Range: 0–255 seconds.
The default is 0.
Delay after far end hangs up before reorder tone is played. 0 = plays immediately, inf =
never plays. Range: 0–255 seconds.
The default is 5.
Expiration time in seconds of a call back activation. Range: 0–65535 seconds.
The default is 1800.
Call back retry interval in seconds. Range: 0–255 seconds.
The default is 30.
Delay after receiving the first SIP 18x response before declaring the remote end is
ringing. If a busy response is received during this time, the SPA9000 still considers the
call as failed and keeps on retrying.
The default is 0.5.
Interval between VMWI refresh to the CPE.
The default is 0.5.
Long timeout between entering digits when dialing. The interdigit timer values are used
as defaults when dialing. The Interdigit_Long_Timer is used after any one digit, if all
valid matching sequences in the dial plan are incomplete as dialed. Range: 0–64 seconds.
The default is 10.
Short timeout between entering digits when dialing. The Interdigit_Short_Timer is used
after any one digit, if at least one matching sequence is complete as dialed, but more
dialed digits would match other as yet incomplete sequences. Range: 0–64 seconds.
The default is 3.
Chapter 6 SPA9000 Field Reference
Document Version 3.01