Using The Ivr Menu - Linksys SPA9000 Administrator's Manual

Chapter 2 Getting Started
The interactive voice response (IVR) features that are available depend on your system configuration.
A convenient quick-reference for the IVR is available at the following website:
http://www.linksys.com/

Using the IVR Menu

To use the IVR menu, complete the following steps.
Step 1
Connect an analog telephone to the Phone 1 or Phone 2 port of the SPA9000.
Note
Step 2
Press **** (quickly press the star key four times).
Wait until you hear "Linksys configuration menu."
Note
Step 3
Refer to
Step 4
Enter the required option followed by the # (pound) key.
To enter a period, use the star key (*).
When entering a value, such as an IP address, to exit without entering any changes, press the * (star) key
twice within half a second. Otherwise, the * is treated as a decimal point.
After entering a value, such as an IP address, press the # (pound) key to indicate you have finished your
selection. To save the new setting, press 1. To review the new setting, press 2. To re-enter the new setting,
press 3. To cancel your entry and return to the main menu, press * (star).
For example, to enter the IP address 191.168.1.105 by keypad, press these keys: 191*168*1*105. Press
the # (pound) key to indicate that you have finished entering the IP address. Then press 1 to save the IP
address or press the * (star) key to cancel your entry and return to the main menu.
If the menu is inactive for more than one minute, the SPA9000 times out. You need to re-enter the menu
by pressing ****.
Step 5
To exit the menu, hang up the telephone.
The settings you have saved take effect after you hang up the telephone. The SPA9000 may reboot at this
time.
Document Version 3.01
You can only access the IVR menu through an analog telephone, not an IP phone.
You cannot access the IVR from a phone that is currently connected to a call.
Table 2-2 to identify the option required.
Using the Interactive Voice Response Interface
Linksys SPA9000 Administrator Guide
2-9