Ivr Options - Linksys SPA9000 Administrator's Manual

Using the Interactive Voice Response Interface

IVR Options

Table 2-2
Table 2-2 IVR Options
IVR Action
Enter IVR Menu
Exit IVR Menu
Check DHCP
Enable/Disable DHCP
Check WAN IP Address
Set Static IP Address
Check Network Mask
Set Network Mask
Check Static Gateway IP
Address
Set Static Gateway IP
Address
Check MAC Address
Check Firmware Version
Check Primary DNS
Server Setting
Linksys SPA9000 Administrator Guide
2-10
summarizes the options provided by the IVR.
IVR Menu Choice Parameter(s)
* * * * None
3948 None
100 None
101 Enter 1 to enable
Enter 0 to disable
110 None
111 Enter IP address using
numbers on the telephone
key pad. Use the * (star) key
when entering a decimal
point.
120 None
121 Enter value using numbers on
the telephone key pad. Use
the * (star) key when entering
a decimal point.
130 None
131 Enter IP address using
numbers on the telephone
key pad. Use the * (star) key
when entering a decimal
point.
140 None
150 None
160 None
Chapter 2
Notes
Ignore SIT or other tones until you hear,
"Linksys configuration menu. Please
enter option followed by the pound key or
hang-up to exit."
IVR announces if DHCP in enabled or
disabled.
Requires password
IVR announces the current IP address of
the WAN port.
DHCP must be "Disabled," otherwise you
hear, "Invalid Option," if you try to set
this value.
Requires password
IVR announces the current network mask
of SPA.
DHCP must be "Disabled," otherwise you
hear, "Invalid Option," if you try to set
this value.
Requires password
IVR announces the current gateway IP
address of SPA.
DHCP must be "Disable," otherwise you
hear, "Invalid Option," if you try to set
this value.
Requires password
IVR announces the MAC address of SPA
in hex string format.
IVR announces the version of the
firmware running on the SPA.
IVR announces the current setting in the
<Primary DNS> parameter.
Document Version 3.01
Getting Started