Sip-Nat Interoperation; Spa9000 Architecture - Linksys SPA9000 Administrator's Manual

Chapter 1 Using the Linksys Voice System

SIP-NAT Interoperation

In the case of SIP, the addresses where messages/data should be sent to a SPA9000 system are embedded
in the SIP messages sent by the device. If the SPA9000 system is sitting behind a NAT device, the private
IP address assigned to it is not usable for communications with the SIP entities outside the private
network.
Note
If the ITSP offers an outbound NAT-Aware proxy, this discovers the public IP address from the remote
endpoint and eliminates the need to modify the SIP message from the UAC.
The SPA9000 system must substitute the private IP address information with the proper external IP
address/port in the mapping chosen by the underlying NAT to communicate with a particular public peer
address/port. For this, the SPA9000 system needs to perform the following tasks:
•
•
•

SPA9000 Architecture

This section describes the basic architecture, function, and configuration options for the SPA9000. It
includes the following topics:
•
•
•
Document Version 3.01
Discover the NAT mappings used to communicate with the peer.
This can be done with the help of an external device, such as a STUN server. A STUN server
responds to a special NAT-Mapping-Discovery request by sending back a message to the source IP
address/port of the request, where the message contains the source IP address/port of the original
request. The SPA9000 system can send this request when it first attempts to communicate with a SIP
entity over the Internet. It then stores the mapping discovery results returned by the server.
Communicate the NAT mapping information to the external SIP entities.
If the entity is a SIP Registrar, the information should be carried in the Contact header that
overwrites the private address/port information. If the entity is another SIP UA when establishing a
call, the information should be carried in the Contact header as well as in the SDP embedded in SIP
message bodies. The VIA header in outbound SIP requests might also need to be substituted with
the public address if the UAS relies on it to route back responses.
Extend the discovered NAT mappings by sending keep-alive packets.
Because the mapping is alive only for a short period, the SPA9000 system continues to send periodic
keep-alive packets through the mapping to extend its validity as necessary.
Architectural Components, page 1-12
Multicast Addressing and Group Paging, page 1-13
Configuration Options, page 1-14
SPA9000 Architecture
Linksys SPA9000 Administrator Guide
1-11