Ivr Options - Linksys 900 Series Administrator's Manual

Using the Interactive Voice Response Interface
To enter a period, use the star key (*).
When entering a value, such as an IP address, to exit without entering any changes, press the
* (star) key twice within half a second. Otherwise, the * is treated as a decimal point.
After entering a value, such as an IP address, press the # (pound) key to indicate you have
finished your selection. To save the new setting, press 1. To review the new setting, press 2. To
re-enter the new setting, press 3. To cancel your entry and return to the main menu, press *
(star).
For example, to enter the IP address 191.168.1.105 by keypad, press these keys:
191*168*1*105. Press the # (pound) key to indicate that you have finished entering the IP
address. Then press 1 to save the IP address or press the * (star) key to cancel your entry and
return to the main menu.
If the menu is inactive for more than one minute, the 900 Series phone times out. You need to
re-enter the menu by pressing ****.
Step 5
To exit the menu, hang up the telephone.
The settings you have saved take effect after you hang up the telephone. The 900 Series phone may
reboot at this time.

IVR Options

Table 2-2
Table 2-2 IVR Options
IVR Action
Enter IVR Menu
Exit IVR Menu
Check DHCP
Enable/Disable DHCP
Check WAN IP
Address
Set Static IP Address
Linksys 900 Series IP Phone Administrator Guide
2-18
summarizes the options provided by the IVR.
IVR Menu Choice Parameter(s)
* * * * None
3948 None
100 None
101 Enter 1 to enable
Enter 0 to disable
110 None
111 Enter IP address using
numbers on the telephone
key pad. Use the * (star)
key when entering a
decimal point.
Chapter 2
Notes
Ignore SIT or other tones until you
hear, "Linksys configuration menu.
Enter option followed by the pound
key or hang-up to exit."
IVR announces whether DHCP is
enabled or disabled.
Requires password
IVR announces the current IP address
of the WAN port.
DHCP must be "Disabled," otherwise
you hear, "Invalid Option," if you try
to set this value.
Requires password
Document Version 3.1
Getting Started