Overhead Ceramic Metal Halide Light Fixtures - Structural Concepts FUSION GMSV6H User Manual

Table of Contents

Advertisement

OVERHEAD CERAMIC METAL HALIDE LIGHT FIXTURES

Overhead Ceramic Metal Halide Light Fixtures
Warning! Lamps are NOT manufactured to
resist breakage. Replace with same wattage
ceramic metal halide lamps (similarly
manufactured). If uncertain of wattage, refer to
label near rear sliding doors for specifics.
Warning! Ceramic heaters also heat up light
fixtures. So check that entire area has been
allowed to cool before touching light fixtures.
See illustration below for light switch that
controls overhead ceramic metal halide lights.
Light switch turns on lights to entire overhead
section of case.
Overhead Ceramic
Thumbscrew
Metal Halide Lamps
Note: Illustration Shown May Not
Exactly Reflect Every Feature or
Option of Your Particular Case.
As ceramic metal halide lamps may take up to 15
minutes to gain full illumination, turn on lamps
BEFORE loading product into case. This will allow
proper time for proper illumination.
------- ------- ------- ------- -------
Warning! Disconnect power before providing
maintenance & service to unit. Allow to cool
for at least 15 minutes before accessing.
After case has been allowed to cool, ceramic
metal halide light fixtures may now be accessed.
To access light fixtures, unscrew thumbscrews
and lower the light fixture (consisting of metal
housing and glass).
Then, access lamps for service, removal,
replacement, etc.
Ceramic Metal
Halide Lamps
11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FUSION GMSV6H and is the answer not in the manual?

This manual is also suitable for:

Fusion gmsv4hFusion gmsv8hFusion gmsv8h.7215

Table of Contents