Figure 2-2
Side-Panel Thumbscrew
NOTE
Removing the Side Panel
1. Remove the two T-15 Torx thumbscrews located in the top and bottom
right edge of the back side of the workstation, as shown below.
Opened Side Panel
Hinge Slots
2. Remove the left side panel by grasping the back edge of the panel and
rotating the panel outward as shown above. Unhinge the panel and
pull it away from the workstation. Set the panel and its screws aside.
Only the left side panel is removed. The left side panel is the one on the
left when facing the front of the workstation.
Chapter 2
System Board Removal/Replacement
Removing the Side Panel
2
Side-Panel Hook
19