Reinstalling The Power Supply - HP Visualize c3600 Upgrade Instructions
Unix workstation
Hide thumbs
Also See for Visualize c3600:
- Owner's manual (246 pages) ,
- Handbook (239 pages) ,
- Administration manual (171 pages)
Table of Contents
Advertisement
Figure 2-19
Spring Hinge
Bail
Lock
Bail
Reinstalling the Power Supply
1. To install the power supply:
a. Pick up the power supply by the handle and position its right-side
hinge pin into the right side hinge bracket, as shown below.
b. Align the shaft of the spring hinge (on the left side) with its hole in
the hinge bracket, release the spring-hinge lever, and let it snap
left into the hole.
c. Reconnect the power supply to the bail lock.
Reinstalling the Power Supply
2. Connect the four power cables.
• Three system power cables
• SCA hard-disk backplane power cable
Chapter 2
System Board Removal/Replacement
Reinstalling the Power Supply
Right-side Hinge Pin
39
Advertisement
Table of Contents
Need help?
Do you have a question about the Visualize c3600 and is the answer not in the manual?
Questions and answers