Sdi Input Control; Input Status; Figure 6-7 : Webeasy - Sdi Input Control Tab - evertz 570J2K-HW-X19 User Manual

570J2K-HW-X19
Multi channel J2K Encoder-Decoder
6.3.

SDI INPUT CONTROL

Figure 6-7 : WebEASY - SDI Input Control Tab
®
The SDI Input Control on the decoder is used to configure the Max Link Rate for the SMPTE2022-6
output provided from the 570J2K-HW-X19.

6.3.1. Input Status

Input Select: This parameter configures the Max Link Rate for the specified channel path. It is used
only when the channel paths are set for Encapsulation. The user can select the following modes
SDI-SD, SDI-HD, 3G-SDI. When configured to SD, the max encapsulation on the link can handle up to
270Mbps. If an HD input is provided, the signal will be clipped. If the Input select is configured to HD,
the max encapsulation on the link can handle up to 1.5Gbps. If a 3G input is provided the signal will be
clipped. When the input select is configured to 3G, the max encapsulation on the link can handle up to
3Gbps.
Video Standard Detected: Reserved for future use.
SDI Loss Count: Reserved for future use.
Input Alias: Reserved for future use.
Clear SDI Loss Count: This button allows the user to clear the SDI loss counter.
Page - 33
Revision 1.0