Advertisement
安全須知
危險
意外事件將會導致人員受傷甚至死亡，也會造成財產的損害。
當有必要進行電控系統的檢修時，務必要關閉電源，並等候至少
５分鐘以上才能打開電控箱／操作箱，以避免電擊。
注意
1. 基本預防
(1) 在操作前務必先閱讀操作手冊與其他機器電件的說明書，
請妥善保存操作手冊與說明書以便隨時查閱。
(2) 這些注意措施包含了機器上加裝，但未列在規格書上的項
目。
(3) 務必要戴護目鏡與手套，以避免破損零件所帶來的傷害。
(4) 有裝戴心臟調節器的人員，請先詢問醫護人員有關注意事
項。.
2. 安全裝置與警告標示
(1) 操作前要檢查 , 並確認所有的安全設施有妥善安裝且運作正
常。
(2) 若安全設施因維修需要有移動，在機器重新啟動操作前，
請確認安全設施有重新安裝回原位，並且運作正常。
(3) 機器上的安全警告標示要保持完整與可辨視。如果有污損
或遺失，請儘以更新。
(4) 未能確實遵守安全規範，將會導致人員受傷，甚至影響生
命安全。
3. 應用與修改
(1) 嚴格禁止機器使用在非原始設計用途。也禁止以任何不是
操作手冊上記載的方式來操作機器 .
(2) 嚴格禁止修改機器。任何未經原廠許可的變動將不在保固
範圍內。
(3) 機台一經修改變動，本公司將不擔負財務損失，人員傷亡
的責任。
4. 教育與訓練
(1) 工廠主管人員有義務提供機台使用人（操作者／維修者）
相關的教育訓練。良好的教育訓練不僅可以避免造成人員
傷害，也可以避免財產的損失。
(2) 操作人員操作機器之前，都必需接受過良好的訓練。
(3) 機器的維修保養必須由合格的技師執行。
5. 必須關閉電源的情況：
如何關閉電源：按壓下緊急停止開關（如果機器有配置的
話），關閉電源，拔除電源線。
(1) 當機器出現異常時，按下緊急停止開關（如果有配置），
關閉電源。
(2) 為了避免機器突然起動造成意外，在操作機器前，要先確
定機器電源關閉，再行開啟電源。
(3) 當檢查或清潔機器時，關閉電源，並確定機器已完全停止
運作。
(4) 當維修機器時（如更換或調整零件），要關閉電源，並確
定機器已完全停止運作。
6. 拔除電源線時，務必要抓住電源插頭，而非抓住電源線，以避
免斷裂，電擊，甚至火災。
7. 當機器停止運作，且無人看管時，要關閉電源。
8. 萬一停電或電力供應出現不穩，關閉電源，以避免意外發生。
SAFETY PRECAUTIONS
Danger
An accident means ＂ to cause personal injury or death, or damage
to property. ＂
When it is necessary to perform service on electrical parts, be sure to
turn the power off and wait for 5 minutes or more before opening the
power cabinet/box in order to avoid electrical shock.
Caution
1. Basic precaution
(1) Read the manual and other papers supplied with accessories
of the machine before operation. Keep the manual and papers
at hand for quick reference.
(2) The content of this section includes items which are not listed in
the specification of your product.
(3) Always wear safety goggles and gloves to avoid accident
caused by parts breakage.
(4) For those who use a heart pacer, please consult the medical
specialist first.
2. Safety devices and warning labels
(1) Check to ensure all safety devices are correctly installed in
place and properly before operation.
(2) If any of the safety devices is removed for service cause, please
be sure to replace it back to position and verify that is works
normally before resuming operation.
(3) Always keep the warning labels adhered on the machine clearly
visible. If any of the labels missing or contaminated, replace
with a new one at soon.
(4) Fail to obey instructions above may cause severe injury or
death to the operators.
3. Application and modification
(1) It is prohibited to use the machine for any application other than
its original intention, or in any manner other than that prescribed
in the instruction manual.
(2) Never modify or alter the machine. Any unauthorized change of
the specification will not be covered by the warranty.
(3) Our company assumes no responsibility/liability to damages,
injuries, or death resulting from the machine which has been
modified or altered.
4. Education and training
(1) The plant managers/supervisors are obliged to provide
education and training to operators and service technicians. A
good education/training plan not only avoids personal injury but
also prevent damage to the property.
(2) Only a well-trained operator is allowed to operate the machine.
(3) Only a certified technician is allowed to perform service to the
machine.
5. Situations that you must turn off the power
Turning off the power: press EMG Stop (if there is one), switch
off the power, and remove the power plug from the outlet.
(1) When there is a failure or abnormality, press EMG Stop (if there
is one), switch off the power.
(2) To prevent accident resulting from abrupt start of the machine,
before operating the machine, always turn off the power and
switch on again.
(3) When cleaning or inspecting the machine, make sure the
machine stops completely after turning off the power.
(4) When performing service (i.e. changing of adjusting any
component), make sure the power is off and the machine stops
completely.
6. Remove the power plug by holding the plug section instead of the
cord to avoid electrical shock, leakage, or fire accident.
7. Turn off the power whenever the machine is left unattended
between works.
8. In case of a power failure or black out, turn off the power to avoid
damage or accident.
Advertisement
