Advertisement
①旋梭與分線勾的間隙
1. 分線勾（1）沿箭頭方向拉滿的時候，
旋松固定螺釘（3），將分線勾（1）
左右調整，使旋梭（2）和分線勾（1）
的間隙為 0.1-0.3mm
2 . 擰緊固定螺釘（3）
注意
間隙過大的情況
●可能發生面線切線錯誤
●面線可能被切短
間隙過小的情況
●會造成旋梭破損
●會造成開松機（1）的破損
②壓腳高度
1. 取下面板（1）上的橡皮塞（2）
2. 旋松螺母 (3)，鬆開壓腳調節螺釘 (4)
3. 通用壓腳扳手（5）抬高壓腳（6）
4. 旋松螺釘（7），上下移動壓腳桿（8）
進行調整，使壓腳（6）上升至針板
上面 7mm
※ 請不要旋轉壓腳桿（8）
5. 擰緊螺釘（7）
6. 通過壓腳調節螺釘（4）調節壓腳壓
力，擰緊螺母（3）
7. 將橡皮塞 (2) 塞⼊面板 (1) 橡皮塞孔內
①
P22
① Clearance between rotary hook and opener
1.Loosen the set screw (3) and move the opener (1) to the left
or right to adjust so that the clearance between the rotary
hook (2) and the opener (1) is 0.1-0.3 mm when the opener (1)
is pulled as it will go in the direction of the arrow
2.Tighten the set screw (3)
NOTE
If the clearance is too large
● Upper thread trimming errors may occur (models with thread
trimmer)
● The right upper thread may be cut may be cut too short
(models with thread trimmer)
If the clearance is too small
● The rotary hook may become damaged
● The opener (1) may become damaged
② Presser foot height
1.Remove the rear cover (1) and remove the rubber cap (2)
2.Loosen the nut (3) and loosen the presser adjusting screw (4)
3.Use the lifting lever (5) to raise the presser foot (6)
4.Loosen the screw (7) and move the presser bar (8) up or
down to adjust so that the presser foot (6) is approximately 7
mm above the top of the needle plate
※ Do not turn the presser bar (8) at this time
5.Tighten the screw (7)
6.Turn the presser adjusting screw (4) to adjust the presser foot
pressure, and then tighten the nut (3)
7. Insert the rubber plug (2) into the rubber plug hole of the
panel (1)
②
Advertisement
