Advertisement
在繞線過程中，不用觸摸任何運動部件或
將物件靠在運動部件上，以為這會導致人
員受傷或縫紉機損壞。
1. 打開電源開關。
2. 將梭芯（1）置於梭芯卷線軸（2）上。
3. 按箭頭所示的方向將線在梭芯（1）上
捲繞几圈。 * 請確認各部分的機線應沒
有鬆弛。
4. 將梭芯壓臂柄（3）推向梭芯（1）。
5. 用壓腳扳手腳壓腳抬起。
6. 踏下腳踏板，隨即開始捲繞底線。
7. 底線繞線一旦完成，梭芯壓臂柄（3）
將自動返回。
8. 底線繞線之後，將梭芯拆下，用切刀
（4）將線剪斷。
* 鬆開螺釘（5），移動梭芯壓桿（6）
調節繞線在梭芯上的底線量。
注意：
繞線在梭芯上的底線量最多應為梭芯容
量的 80％。
Do not touch any of the moving parts or press any objects against
the machine while winding the lower thread, as this may result in
personal injury or damage to the machine.
1.Turn on the power switch.
2.Place the bobbin (1) onto the bobbin winder shaft (2).
3.Wind the thread several times around the bobbin (1) in the
direction indicated by the arrow.
*Check that the thread is not loose anywhere along the thread
path.
4.Push the bobbin presser arm (3) toward the bobbin (1).
5.Raise the presser foot with the lifting lever.
6.Depress the treadle.Lower thread winding will then start.
7.Once winding of the lower thread is completed,the bobbin
presser arm (3) will return automatically.
8.After the thread has been wound on, remove the bobbin and cut
the thread with the knife (4).
* Loosen the screw (5) and move the bobbin presser (6) to
adjust the amount of thread wound onto the bobbin.
NOTE：
The amount of thread wound onto the bobbin should be a
maximum of 80% of the bobbin capacity.
P7
Advertisement
