Important Safety Instructions - Siruba DL7200D-NM1 Instruction Book

To get the most out of the many functions of this machine and operate it in safety, it is necessary to use this machine correctly.
Please read this instruction Manual carefully before use. We hope you will enjoy the use of your machine for a long time.Please
remember to keep this manual in a safe place.
1.Observe the basic safety measures, including, but not limited to the following ones, whenever you use the machine.
2.Read all the instructions,including, but mot limited to this Instruction Manual before you use the machine. In addition, keep
this Instruction Manual so that you read it at anytime when necessary.
3.Use the machine after it has been ascertained that it conforms with safety rules/standards valid in your country.
4.All safety devise must be in position when the machine is ready for word or in operation.
The operation without the specified safety devices is not allowed.
5.This machine shall be operated by appropriately-trained operators.
6.For your personal protection, we recommend that you wear safety glasses.
7.For the following, turn off the power switch or disconnect the power plug of the machine from the receptacle.
7-1 For threading needle(s), looper, spreader etc. And replacing bobbin.
7-2 For replacing part(s) of needle, presser foot, throat plate, looper, spreader,feed dog ,needle guard, folder, cloth guide ect.
7-3 For repair work.
7-4 When leaving the work place or when the working place is unattended.
8.If you should allow oil, grease, etc. Use with the machine and devices to come in contact with your eyes or skin or swallow
any of such liquid by mistake, immediately wash the contacted areas and consult a medical doctor.
9.Tampering with the live parts and devices, regardless of whether the machine is powered, is prohibited.
10.Repair, remodeling and adjustment works must only be done by appropriately trained technicians or specially skilled
Personnel. Only spare parts designated by can be used for repairs.
11.General maintenance and inspection works have to be done by appropriately trained personnel.
12.Repair and maintenance works of electrical components shall be conducted by qualified electric technicians or under
the audit and guidance of specially skilled personnel.
13.Before making repair and maintenance works on the machine equipped with pneumatic parts such as an air cylinder,he
air compressor has to be detached from the machine and the compressed air supply has to be cut off.Existing residua
lair pressure after disconnecting the air compressor from the compressed air supply has to be expelled. Exceptions to
this are only adjustments and performance checks done by appropriately trained technicians or specially skilled personnel.
14.Periodically clean the machine throughout the period of use.
15.Grounding the machine is always necessary for the normal operation of the machine. The machine has to be operated in
an environment that is free from strong noise sources such as high-freauency welder.
16.An appropriate power plug has to be attached to the machine by electric technicians. Power plug has to be commected
to a grounded receptacle.
17.Grounding the machine is always necessary for the normal operation of the machine. The machine has to be operated in
an environment that is free from strong noise sources such as high-freauency welder.
18.An appropriate power plug has to be attached to the machine by electric technicians. Power plug has to be commected
to a grounded receptacle.
19.Warming hints are marked with the two shown symbols.
Danger of injury to operator or service staff
Items requiring special attention

IMPORTANT SAFETY INSTRUCTIONS

-2-